Updating a 2000s Fletcher craftsman home's weathered exterior

The exterior no longer looked consistent

The homeowner noticed worn, uneven siding across the exterior of this two-story Fletcher home. The craftsman-style design and front porch made the siding lines easy to see, so mismatched panels and tired trim stood out from the yard and approach.

They called us to replace the failing exterior with a defined scope rather than patching isolated areas without checking the surrounding wall. Because the home was built in the 2000s, our team also looked for installation details that could affect how new siding would meet the existing wall assembly.

The wall details set the installation scope

Our technicians inspected the siding, corners, panel courses and soffit-adjacent trim before removing material. We checked the exposed wall surface as each area opened up, looking for conditions that would affect a weather-resistant exterior wall envelope.

The inspection also guided the replacement sequence. North Carolina requirements call for a water-resistant barrier behind exterior veneer, flashing and a way for water entering the assembly to drain outward. Vinyl siding must be certified to ASTM D3679 and installed according to the manufacturer's instructions, so those details stayed part of our planning.

How we completed the Fletcher siding job

1. Inspect the exterior

   We walked the two-story home, checked the siding courses and identified the areas where worn panels and adjacent trim needed to come out together.

2. Protect the work area

   Our team prepared the front porch and nearby work areas before removing siding, keeping the installation path organized around the home's traditional craftsman-style exterior.

3. Remove worn siding

   We took off the affected siding and checked the exposed wall surface rather than covering uncertain conditions. This gave us a clear basis for the replacement scope.

4. Install the new panels

   We installed the new vinyl siding with the required wall-envelope details in mind, following the product installation instructions and fitting the courses around corners and soffit-adjacent trim.

5. Check the finished exterior

   We reviewed the panel alignment, corners, seams and trim, then cleaned the work area. The final check confirmed that the visible siding lines were consistent across the home.

A consistent finish after one visit

The Fletcher home finished with a uniform exterior that better suited its two-story craftsman-style form and deep front porch. The new siding replaced the worn sections with aligned courses and coordinated trim at the areas included in the siding scope.

Our team completed the job in one visit during spring. The homeowner received a focused exterior update based on the actual wall condition, not a vague allowance for unknown siding work.

What shaped this mid-range investment

The cost came from the amount of exterior siding to remove and install, the two-story layout, and the wall details that had to be checked before the new panels went on. We built the scope around this Fletcher home's actual surfaces and access needs.